0 Votes

Export

Last modified by Casper Egholm Hougaard on 2024/02/09 10:22

Contents of this page:

Export options

There are multiple export options within PREFAB for exporting to other file formats. This can be done in the viewer (Display of models) or the dedicated tab (Export to other file formats). 

1707468241008-689.png

  1. Export to StruXML
    • Wall elements results along edges
    • Reactions
  2. Export to Excel
    • Results
    • Geometry
  3. Locked format

Note: The options are currently dependent on what type of calculation has been run.

Export to StruXML

This creates a StruXML file to be used in FEM-Design. There are two main options:

Wall elements results along edges

Every wall is modeled independently ot the others. With loads automatically applied according to the PREFAB calculations. Every load combination picked for export is also automatically created in FEM-Design.

Points supports are added with a soft stiffness. They are used to counter minuscule equilibrium errors. 

1707469276181-465.png

As a verification check, the reactions for the load combinations (Not load cases) should be controlled after the analysis. If the reactions found are not negligible, return to PREFAB and rerun the calculation to check for errors. If everything appears fine, please contact support, for guidance.

Reactions

Reactions, matching the calculation made in PREFAB will be generated as load in a FEM-Design model. Line loads for walls, and point loads for anchors. 

It will keep the coordinates from the originally imported FEM-Design model. All selected load combinations will be created automatically.

1707469561923-544.png

Export to Excel

This creates an Excel file. There are two main options:

Results

The Result file will contain information about:

  • Shell elements
    • qRd : Design capacity [kN/m]
    • u : Utilization as decimal [ - ] (1 = 100%)
  • MAX results
  • Rebar anchorages 
  • Loads

Geometry

The Geometry file will contain information about: 

  • Shell elements
  • Holes
  • Beams and columns

Exporting via: Export to other file formats

Exporting using the Export to other file formats tab gives you the full list options available for your calculation:  

1707468264154-160.png

Exporting via: Display of models

Inside the Display of models, you can manually select elements, right-click, and then choose the export type you want: 

1707468274988-413.png