Create your first FEM-Design objects through the FEM-Design API for Dynamo.

Create plates

helloWorld.PNG

Dynamo node graph:

Tasks:

  • Try to run the .dyn file in Dynamo to open the model in FEM-Design.
  • Try to re-scale the model and open it in FEM-Design.
  • Try to change the material from "C30/37" to for example "C20/25".

Relevant actions and methods:

Create supports

helloWorld_support.PNG

Dynamo node graph:

Tasks:

  • Try to run the .dyn file in Dynamo to open the model in FEM-Design with supports added.
  • Try to change the line support to type "Fixed".

Relevant actions and methods:

Create loads

helloWorld_loads.PNG

Dynamo node graph:

Tasks:

  • Try to run the .dyn file in Dynamo to open the model in FEM-Design with loads added.
  • Try to increase the load intensity to 10 kN/m2 in the negative global Z-Axis.
  • Try to change the name of the load case of the load.
  • Try to set a comment to the load.

Relevant actions and methods:

Run analysis

helloWorld_translation.PNG

Dynamo node graph:

Tasks:

  • Try to run the .dyn file in Dynamo to perform an analysis.
  • Try to run the analysis but close FEM-Design when finished.
  • Try to run a load combination calculation instead of a load case calculation.
    • In order to do this you have to create a load combination in the node graph and add it to the Model.CreateNewModel function.
  • Try to set creep and shrinkage to concrete material of plates.

Relevant actions and methods:

Created by Isak Björhag on 2019/09/30 14:07
Copyright 2020 StruSoft AB
FEM-Design Wiki