<
From version < 237.1 >
edited by Fredrik Lagerström
on 2020/04/01 14:33
To version < 238.1 >
edited by Fredrik Lagerström
on 2020/04/02 08:36
>
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -134,6 +134,15 @@
134 134  
135 135  = {{id name="Analysis for Construction stages"/}}Analysis for Construction stages =
136 136  
137 +(% class="box infomessage" %)
138 +(((
139 +For further information see:
140 +• [[Structure definition of Construction stages>>doc:Manuals.User Manual.Structure definition.Construction stages (Geometry).WebHome]].
141 +• [[Load definitions for Construction stages>>doc:Manuals.User Manual.Loads.WebHome||anchor="Construction stages"]]
142 +• [[Analysis for Construction stages>>doc:Manuals.User Manual.Analysis.WebHome||anchor="Analysis for Construction stages"]]
143 +)))
144 +
145 +
137 137  User can start the construction stage calculation at Analysis/Calculation/Construction stages. There is two calculation method, so called //Incremental “Tracking” method// and //“Ghost” structure method.//
138 138  
139 139  When incremental method is chosen, the model is built stage-by-stage. In case of “ghost” structure method the full structure is in the calculation, but stiffness of those structural parts which aren’t in the specific stage is highly reduced.
... ... @@ -148,7 +148,6 @@
148 148  
149 149  [[image:1585304895405-781.png]]
150 150  
151 -
152 152  = {{id name="Analysis for Load Cases and Combinations"/}}Analysis for Load Cases and Combinations =
153 153  
154 154  Analysis calculations can be done by load case and/or load combination. The next table summarizes the results available for load cases and load combinations by FEM-Design modules.
... ... @@ -538,7 +538,6 @@
538 538  
539 539  |(% style="width:120px" %)[[image:warning.png]]|(% style="width:1322px" %)For columns only this (//“Cantilever and column”//) option is available.|
540 540  
541 -
542 542  [[image:1585566012700-385.png]]
543 543  
544 544  
... ... @@ -825,7 +825,6 @@
825 825  It is uninterested in the calculation point of view, that effective masses are compared to the total or the reduced mass, because these values are given in percentage and only gives information, that which mode shape is the fundamental or which shapes are dominant in a given direction.
826 826  )))
827 827  
828 -
829 829  At //Options//, more calculation properties can be set:
830 830  
831 831  * **Combination rule**
Copyright 2020 StruSoft AB
FEM-Design Wiki